DMP1 / Dentin matrix acidic phosphoprotein 1 · Western blot design guide

Design a Western Blot for DMP1

Real validated DMP1 Western blot protocols, expected-band and isoform facts, troubleshooting for weak or shifted signal, and recommended anti-DMP1 WB antibodies. Everything you need to plan the experiment before you commit precious samples.

Evidence assembled September 2026 · For research use; verify linked source records and product datasheet before use
Western blot protocol sheet for DMP1: expected band ~55.8 kDa, hero antibody A01984, catalog values and labelled standard workflow; separate PMC comparisons on the guide
Printable DMP1 Western blot protocol sheet — expected band ~55.8 kDa, antibody A01984, controls and PMC citations. Open the full DMP1 WB guide →

DMP1 Western Blot Experimental Design Guide

Expected bands, validated protocols, controls and antibodies — the at-a-glance facts below, then the full design guide.

Must know before running
Expected band ~55.8 kDa
Gel 12–15% (standard starting point)
Positive control ⓘ Adipose tissue (IHC candidate; verify WB) +4 more
Negative control ⓘ Suggested KO / knockdown lysate
Important caveats
Reasons your observed band may differ from the expected size.
PTM Glycosylated + Phosphorylated
Caveat Modification-state controls
Gene-set association MSigDB Hallmark membership
Isoform 2 isoform(s)
Section 1

Real Curated DMP1 Western Blot Protocols

The A01984 protocol combines labelled catalog values with standard starting conditions. Published comparisons retain their own sample, reagent and detection scope.

Recommended Western blot protocol parameters
Sample / lysateTarget-positive lysate and matched negative control (standard starting point)
Gel %12–15% (standard starting point)
Load20–30 µg total protein per lane; optimize for abundance (standard starting point)
TransferStandard semi-dry transfer; verify efficiency (standard starting point)
Membrane0.45 µm PVDF (standard starting point)
Blocking5% milk or 5% BSA in TBST (standard starting point)
Primary antibodyA01984; use the WB datasheet starting dilution (standard starting point)
Primary incubationOvernight at 4 °C (standard starting point)
Secondary antibodySpecies-matched HRP conjugate at validated dilution (standard starting point)
Secondary incubation1 h at room temperature (standard starting point)
Wash3 × 5 min in TBST (standard starting point)
DetectionECL; bracket exposures to avoid saturation (standard starting point)
Section 2

What Is the Expected DMP1 Western Blot Band Size?

DMP1 has a predicted 55.8 kDa precursor; signal-peptide removal, N-linked glycosylation, and isoforms could affect migration, but no empirical band size or effect is established.

What am I looking at on my blot?
Band near 55.8 kDaConsistent with the predicted DMP1 precursor mass; identity needs confirmation
Band slightly below 55.8 kDaCould reflect removal of the 1–16 signal peptide
Band above 55.8 kDaCould reflect N-linked glycosylation; its migration effect is unverified
More than one bandIsoforms 1 and 2 are possible contributors, but distinct migration is unverified
Little or no band in whole-cell lysateDMP1 can localize to the extracellular matrix
💡Expected DMP1 appearanceUniProt predicts a 55.8 kDa DMP1 precursor; no empirical band size is supplied, and signal-peptide removal, N-linked glycosylation, or isoforms could affect migration, so confirm band identity with appropriate controls.
How each factor affects band size
UniProt predicted mass55.8 kDa for the precursor; apparent migration is unverified
Signal peptide at residues 1–16Its removal could make mature DMP1 smaller than the precursor
N-linked glycosylation at Asn25, Asn285, Asn324, and Asn345Could increase apparent size or alter migration; a visible effect is unverified
N-linked glycosylation at Asn351, Asn413, Asn426, and Asn467Could increase apparent size or alter migration; a visible effect is unverified
Isoforms 1 and 2May differ in size, but their masses and migration difference are not supplied
Why is my band missing or off?
SituationLikely causeNext action
No band in lysateDMP1 can be secreted into the extracellular matrixCheck conditioned medium or extracellular matrix alongside lysate
Band higher than expectedN-linked glycosylation is possible, but the cause of a shift is unverifiedCompare with an appropriate glycosidase-treated sample and confirm band identity
Band lower than expectedRemoval of the 1–16 signal peptide could lower precursor massConfirm band identity and check whether the antibody recognizes the detected form
Broad smear instead of sharp bandHeterogeneous N-linked glycosylation is possible but unverifiedCompare glycosidase-treated and untreated samples
Multiple bandsIsoforms 1 and 2 could contribute, but distinct migration is unverifiedUse an independent antibody or targeted knockdown to assess band identity
Weak or no signalDMP1 location varies among nucleus, cytoplasm, and extracellular matrixCompare cellular and extracellular fractions from the relevant cell state

Sample controls for DMP1 Western blot

🧪HPA-IHC candidate guidance (verify in WB): For positive controls for DMP1 in Western blot, you can use adipose tissue, an HPA medium-expression tissue.
Positive control: Adipose tissue (IHC candidate; verify WB)
Negative control: Suggested KO / knockdown lysate
Loading controls: Run GAPDH, β-actin, and a total-protein stain alongside the samples.
⚠️Feasibility: DMP1 is secreted, so whole-cell lysate may show little signal; consider conditioned medium.

HPA tissue expression evidence for DMP1

Comprehensive Human Protein Atlas IHC scoring per tissue. Rows are taken directly from the HPA tissue chart — click any row's HPA link to view the source.

Higher expression tissues · candidate positive controls from IHC

TissueCell typeLevelEvidenceSource
Adipose tissue adipocytes Medium Protein (IHC) HPA →
Adrenal gland glandular cells Medium Protein (IHC) HPA →
Appendix glandular cells Medium Protein (IHC) HPA →
Bone marrow hematopoietic cells Medium Protein (IHC) HPA →
Breast glandular cells Medium Protein (IHC) HPA →

Lower expression tissues · IHC evidence, not confirmed WB-negative controls

TissueCell typeLevelEvidenceSource
Caudate neuronal cells Low Protein (IHC) HPA →
Hippocampus glial cells Low Protein (IHC) HPA →
Lymph node non-germinal center cells Low Protein (IHC) HPA →
Ovary ovarian stroma cells Low Protein (IHC) HPA →
Salivary gland glandular cells Low Protein (IHC) HPA →
Section 3

Advanced DMP1 Western Blot Tips

Deeper troubleshooting and optimisation questions for DMP1, answered from its protein features.

How should DMP1 band migration be interpreted?
Band shift · Use the separately labelled calculated mass and catalog-observed evidence above. A sequence annotation does not establish an observed migration shift. Verify target identity with orthogonal controls.
Could DMP1 isoforms produce different bands?
Isoforms · UniProt lists isoforms 1 and 2. Isoform 2 lacks residues 46–61 of the canonical sequence. Check whether the antibody’s epitope includes that region before interpreting a band as isoform 2; the sequence difference alone does not establish two visible bands.
Which DMP1 glycosylation sites matter when interpreting bands?
PTM · The supplied UniProt coordinates list N-linked glycosylation at Asn25, Asn285, Asn324, Asn345, Asn351, Asn413, Asn426, and Asn467. These are canonical-sequence coordinates; antibody or paper numbering may differ. Their annotation does not establish that glycosylation caused a particular band shift.
Does this guide establish induction of DMP1?
Induction · No general induction response is established by this guide. A pathway or gene-set association is not evidence of induction in a particular specimen. Verify the relevant treatment and control in a target-specific experiment.
How should transfer be checked for DMP1?
Transfer · Standard workflow guidance: verify transfer efficiency for the intended target size before interpreting a weak signal. Use total-protein assessment and optimize transfer for the membrane, gel and apparatus; the labelled catalog values take precedence.
How should blocking be optimized?
Blocking · Standard workflow guidance: follow the A01984 datasheet where specified. Otherwise compare 5% milk or 5% BSA in TBST; for a phospho-specific assay start with BSA. Optimize background and specific signal with matched controls.
How should DMP1 be quantified across samples?
Quantitation · Keep cell stage and sample fraction consistent across comparisons. DMP1’s annotated location changes between proliferating preosteoblasts and early maturation, so a change in one fraction may reflect redistribution. Quantify the same defined band or bands across samples and report which fraction was measured.
Should DMP1 run at its predicted 55.8 kDa?
Interpretation · The 55.8 kDa prediction is for the 513-residue sequence, which includes a signal peptide at positions 1–16. DMP1 also has annotated glycosylation sites. These features alone cannot predict its apparent Western blot mass, and no observed band size was supplied.

DMP1 is annotated in the nucleus, cytoplasm, and extracellular matrix. The supplied location note places it in the nucleus of proliferating preosteoblasts and the cytoplasm during early maturation. Choose fractions to match the cell stage and location being studied, and compare like fractions.

Check whether the antibody recognizes the isoform 2 deletion at canonical residues 46–61, and consider the signal peptide at 1–16 and the annotated N-linked glycosylation sites. None of these features alone identifies an unexpected band. No empirical DMP1 band size was supplied for comparison.
Boster reagents

DMP1 Western Blot Antibodies

Catalog antibodies with Western blot application and product-specific WB images. Evaluate suitability with the reported sample, controls and experimental conditions.

Real WB data WesternBlot (WB) analysis of DMP1 polyclonal antibody
Anti-DMP1 Antibody
Cat # A01984

The catalog reports A01984, an anti-DMP1 polyclonal antibody with stated Human and Mouse reactivity and a Western blot image. The supplied record gives no sample details or validation conditions, so the image alone does not establish performance across both species.

Which to pick: A01984 is the only listed DMP1 antibody. It has a WB image and stated Human and Mouse reactivity; check the full image caption and conditions against your sample before choosing it.

Source: BosterBio DMP1 gene-info card — filtered to Western-blot-capable antibodies; each card shows that product's actual WB validation figure.