ZNF217 / Zinc finger protein 217 · Western blot design guide

Design a Western Blot for ZNF217

Source-linked ZNF217 Western blot protocol options, expected-band and isoform facts, troubleshooting for weak or shifted signal, and recommended anti-ZNF217 WB antibodies. Everything you need to plan the experiment before you commit precious samples.

Evidence assembled September 2026 · For research use; verify linked source records and product datasheet before use
Western blot protocol sheet for ZNF217: expected band ~115.3 kDa, hero antibody M03921-2, catalog values and labelled standard workflow; separate PMC comparisons on the guide
Printable ZNF217 Western blot protocol sheet — expected band ~115.3 kDa, antibody M03921-2, controls and PMC citations. Open the full ZNF217 WB guide →

ZNF217 Western Blot Experimental Design Guide

Expected bands, source-linked protocol options, controls and antibodies — the at-a-glance facts below, then the full design guide.

Must know before running
Expected band ~115.3 kDa
Gel 8–10% (standard starting point)
Positive control ⓘ Cervix (IHC candidate; verify WB) +4 more
Negative control ⓘ Adipose tissue (IHC candidate; verify WB)
Important caveats
Reasons your observed band may differ from the expected size.
PTM Phosphorylated + Ubl conjugation
Caveat Modification-state controls
Gene-set association MSigDB C7 membership
Isoform 1 isoform(s)
Section 1

Source-Linked ZNF217 Western Blot Protocol Options

The M03921-2 protocol combines labelled catalog values with standard starting conditions. Published comparisons retain their own sample, reagent and detection scope.

Recommended Western blot protocol parameters
Sample / lysateCaco2 cell lysate (catalog M03921-2)
Gel %8–10% (standard starting point)
Load20–30 µg total protein per lane; optimize for abundance (standard starting point)
TransferWet/tank transfer; optimize duration (standard starting point)
Membrane0.45 µm PVDF (standard starting point)
Blocking5% milk or 5% BSA in TBST (standard starting point)
Primary antibodyM03921-2; use the WB datasheet starting dilution (standard starting point)
Primary incubationOvernight at 4 °C (standard starting point)
Secondary antibodySpecies-matched HRP conjugate at validated dilution (standard starting point)
Secondary incubation1 h at room temperature (standard starting point)
Wash3 × 5 min in TBST (standard starting point)
DetectionECL; bracket exposures to avoid saturation (standard starting point)
Section 2

What Is the Expected ZNF217 Western Blot Band Size?

ZNF217 is predicted at 115.3 kDa; annotated modifications could affect migration, but no visible shift or empirical band size is established.

What am I looking at on my blot?
Band near 115.3 kDaconsistent with the predicted full-length ZNF217 mass; confirm its identity with antibody controls
Faint band in whole-cell lysatenuclear ZNF217 may be easier to detect after nuclear enrichment
Band above 115.3 kDacould reflect a modified form, but its identity and migration are unestablished
Doublet near 115.3 kDacould reflect different modification states; confirm both bands as ZNF217
💡Expected ZNF217 appearanceFull-length ZNF217 has a predicted mass of 115.3 kDa, but no empirical band size is supplied; verify any candidate band with ordinary band-identity controls.
How each factor affects band size
Predicted full-length massprovides a 115.3 kDa reference, not a measured migration position
Phosphoserine sitesare annotated, but no apparent size change is established
Phosphothreonine sitesare annotated, but no apparent size change is established
Ubl conjugation annotationmay affect migration, but no band position is supplied
Why is my band missing or off?
SituationLikely causeNext action
No band in lysatenuclear localization may limit detection in the sampled fractioncheck a nuclear fraction and confirm sample loading
Band higher than expecteda modified ZNF217 form is possible but unconfirmedconfirm identity with an independent antibody or ZNF217 depletion
Band lower than expectedthe band may be a fragment or nonspecific signalconfirm identity with ZNF217 depletion and a second antibody
Multiple bandsmodification states or nonspecific binding are possibletest which bands track with ZNF217 depletion
Weak or no signalinsufficient nuclear protein or low ZNF217 abundanceenrich the nuclear fraction and check loading and antibody performance
Fragments below expected sizesample degradation is possiblecheck sample handling and confirm fragment identity with a second antibody

Sample controls for ZNF217 Western blot

🧪HPA-IHC candidate guidance (verify in WB): For positive controls for ZNF217 in Western blot, you can use cervix tissue, which HPA scores High.
Positive control: Cervix (IHC candidate; verify WB)
Negative control: Adipose tissue (IHC candidate; verify WB)
Loading controls: Run GAPDH, β-actin, and a total-protein stain alongside the samples.
⚠️Feasibility: HPA identifies both high-expression and not-detected tissues, making tissue controls feasible for this nuclear protein.

HPA tissue expression evidence for ZNF217

Comprehensive Human Protein Atlas IHC scoring per tissue. Rows are taken directly from the HPA tissue chart — click any row's HPA link to view the source.

Higher expression tissues · candidate positive controls from IHC

TissueCell typeLevelEvidenceSource
Cervix glandular cells High Protein (IHC) HPA →
Colon peripheral nerve/ganglion High Protein (IHC) HPA →
Duodenum glandular cells High Protein (IHC) HPA →
Fallopian tube ciliated cells (cell body) High Protein (IHC) HPA →
Kidney cells in tubules High Protein (IHC) HPA →

Lower expression tissues · IHC evidence, not confirmed WB-negative controls

TissueCell typeLevelEvidenceSource
Adipose tissue adipocytes Not detected Protein (IHC) HPA →
Bone marrow hematopoietic cells Not detected Protein (IHC) HPA →
Spleen cells in red pulp Not detected Protein (IHC) HPA →
Cerebral cortex endothelial cells Low Protein (IHC) HPA →
Hippocampus glial cells Low Protein (IHC) HPA →
Section 3

Advanced ZNF217 Western Blot Tips

Deeper troubleshooting and optimisation questions for ZNF217, answered from its protein features.

How should ZNF217 band migration be interpreted?
Band shift · Use the separately labelled calculated mass and catalog-observed evidence above. A sequence annotation does not establish an observed migration shift. Verify target identity with orthogonal controls.
Could documented isoforms explain multiple ZNF217 bands?
Isoforms · UniProt lists one isoform and no alternative sequence. This record therefore does not support assigning multiple bands to documented isoforms; verify additional bands independently.
Which ZNF217 phosphorylation sites matter when interpreting bands?
PTM · UniProt lists phosphoserine at 106, 321, 407, 593, 662 and 795, and phosphothreonine at 322 and 648. These are UniProt sequence coordinates; antibody or paper numbering may differ. Their presence does not establish a detectable mobility shift.
Does this guide establish induction of ZNF217?
Induction · No general induction response is established by this guide. A pathway or gene-set association is not evidence of induction in a particular specimen. Verify the relevant treatment and control in a target-specific experiment.
What transfer method to use for ZNF217 Western blot?
Transfer · Plan transfer around ZNF217’s predicted 115.3 kDa mass. Check transfer efficiency in that size region with a protein stain or marker, and adjust transfer conditions if protein remains in the gel. UniProt does not specify a transfer method.
How should blocking be optimized?
Blocking · Standard workflow guidance: follow the M03921-2 datasheet where specified. Otherwise compare 5% milk or 5% BSA in TBST; for a phospho-specific assay start with BSA. Optimize background and specific signal with matched controls.
How can ZNF217 bands be quantified consistently?
Quantitation · Measure the same verified ZNF217 band across samples and normalize to a suitable loading measure for the preparation used. Its listed nuclear location makes consistent sample preparation especially relevant; the UniProt features do not establish which band an antibody detects.
Where should ZNF217 appear relative to its predicted mass?
Interpretation · ZNF217 has a predicted mass of 115.3 kDa. No observed band position is supplied, so use that value as a starting point and confirm candidate bands experimentally. Listed modifications alone do not establish a visible shift.

ZNF217 is listed in the nucleus. If using nuclear extracts, keep the extraction and loading approach consistent across samples and verify that the preparation contains nuclear protein.

Start with the predicted 115.3 kDa mass and the single listed isoform. ZNF217 has eight listed phosphorylation sites, but they do not by themselves identify another band or prove a shift. Verify band identity before attributing additional signals to ZNF217.
Boster reagents

ZNF217 Western Blot Antibodies

Catalog antibodies with Western blot application and product-specific WB images. Evaluate suitability with the reported sample, controls and experimental conditions.

Real WB data Western blot analysis of ZNF217 expression in Caco2 cell lysate.
Anti-ZNF217 Rabbit Monoclonal Antibody
Cat # M03921-2

The listed anti-ZNF217 rabbit monoclonal antibody, M03921-2, has reported human reactivity and a Western blot image using Caco2 cell lysate. No publication evidence or validation in other samples is supplied.

Which to pick: M03921-2 is the only listed option and the only one with a Western blot image. Its Caco2 lysate example is the relevant evidence when choosing it for a human ZNF217 blot.

Source: BosterBio ZNF217 gene-info card — filtered to Western-blot-capable antibodies; each card shows that product's actual WB validation figure.