GRIN1 Western Blot Experimental Design Guide

Expected bands, validated protocols, controls and antibodies — the at-a-glance facts below, then the full design guide.

Must know before running
Expected band 105.4 kDa observed
Observed band 105.4 kDa observed
Gel 8-10%
Positive control ⓘ Cerebellum
Negative control ⓘ Bone marrow
Important caveats
Reasons your observed band may differ from the expected size.
ⓘCalculated mass105.4 kDa
ⓘLocalizationCell membrane / Postsynaptic cell membrane
ⓘProcessing / PTMRecord-dependent
ⓘReactivityHuman / Mouse / Rat
Section 1

Real Curated GRIN1 Western Blot Protocols

Start with the molecular-weight rule, then compare verified publication-derived conditions.

Recommended Western blot protocol parameters
Sample / lysateCerebellum
Gel %8-10%
Load20-30 µg total protein per lane
TransferWet/tank, extended transfer
Membrane0.45 µm PVDF
Blocking5% non-fat milk or 5% BSA in TBST
PrimaryA01808 at datasheet starting dilution
Primary incubationOvernight at 4 °C with gentle agitation
SecondarySpecies-matched HRP conjugate at validated dilution
Wash3 × 5 min in TBST
DetectionChemiluminescent substrate
ExposureBracket exposures to avoid saturation
Section 2

What Is the Expected GRIN1 Western Blot Band Size?

Use the product-observed 105.4 kDa band as the primary planning value and retain the UniProt calculated mass as context.

What am I looking at on my blot?
105.4 kDaMatches the authoritative product WB observation.
105.4 kDa calculatedUse as UniProt context, not as a replacement observed band.
Unexpected additional signalDo not assign identity without orthogonal positive/negative controls.
💡Expected GRIN1 appearancePlan around 105.4 kDa and keep the calculated mass as supporting context.
How each factor affects band size
Catalog-observed band105.4 kDa; use this as the primary experimental expectation.
Calculated mass105.4 kDa from UniProt Q05586; retain as context.
Gel selection8-10%; shared with the recommended protocol and poster.
Specificity checkCompare the lead HPA positive and negative controls with A01808.
Why is my band missing or off?
SituationLikely causeNext action
105.4 kDaMatches the authoritative product WB observation.Confirm with orthogonal controls and the linked product record.
Additional bandMay reflect processing, modification, or non-specific signal.Run a dilution series and compare positive/negative controls.
Weak signalTarget abundance or transfer may be limiting.Verify transfer, increase positive-control abundance, and bracket exposure.

Sample controls for GRIN1 Western blot

🧪Use Cerebellum as the first positive-control candidate and retain an orthogonal negative control.
Positive control: Cerebellum (Medium)
Negative control: Bone marrow (Not detected)
HPA protein score determines control status; other expression data is supporting context only.

HPA tissue expression evidence for GRIN1

Comprehensive Human Protein Atlas IHC scoring per tissue. Rows are taken directly from the HPA tissue chart on each tissue page — click any row's HPA link to view the source.

Positive expression · recommended positive controls

Tissue Cell type Level Evidence Source
Cerebellum Reported tissue cells Medium Protein (HPA) HPA →
Hippocampus Reported tissue cells Medium Protein (HPA) HPA →
Cerebral cortex Reported tissue cells Medium Protein (HPA) HPA →
Adrenal gland Reported tissue cells Low Protein (HPA) HPA →

Undetected expression · recommended negative controls

Tissue Cell type Level Evidence Source
Bone marrow Reported tissue cells Not detected Protein (HPA) HPA →
Cervix Reported tissue cells Not detected Protein (HPA) HPA →
Section 3

Advanced GRIN1 Western Blot Tips

Deeper troubleshooting and optimisation questions for GRIN1, answered from its protein features.

Which band should guide the blot?
Use 105.4 kDa, the observation attached to the authoritative A01808 WB record.
How should calculated mass be interpreted?
Treat the UniProt calculated mass as context; it does not replace the catalog-observed 105.4 kDa expectation.
Which positive control should I start with?
Start with Cerebellum, the lead HPA protein-expression candidate.
Which negative control is defensible?
Use Bone marrow as an orthogonal HPA Not detected candidate.
Which gel should I use?
Use 8-10% consistently across the quick facts, protocol table, and poster.
What transfer method to use for GRIN1 Western blot?
Use the transfer method in the recommended protocol and verify transfer before blocking.
How should A01808 be started?
Start at the linked datasheet condition and run a three-point primary-antibody dilution test.
Which publication-derived protocols can I compare?
No verified publication protocol was supplied; use only the deterministic recommended protocol.
Boster reagents

GRIN1 Western Blot Reagents

Human/Mouse/Rat-reactive GRIN1 Western blot reagents with authoritative product imagery.

Real WB dataWestern blot validation image for GRIN1 using A01808; observed band 105.4 kDa
Anti-NMDAR1/GRIN1 Antibody Picoband®
Cat # A01808
Real WB dataWestern blot validation image for GRIN1 using PA1222; observed band 105.4 kDa
Anti-NMDAR1/GRIN1 Antibody Picoband®
Cat # PA1222

Only image-backed, WB-validated Human/Mouse/Rat recommendations from the prepared catalog evidence are shown.

Source: prepared picoband-wb product evidence; each card retains its own SKU, URL, observed band, and authoritative WB image.