KRT10 / Keratin, type I cytoskeletal 10 · Western blot design guide

Design a Western Blot for KRT10

Real validated KRT10 Western blot protocols, expected-band and isoform facts, troubleshooting for weak or shifted signal, and recommended anti-KRT10 WB antibodies. Everything you need to plan the experiment before you commit precious samples.

Evidence assembled September 2026 · For research use; verify linked source records and product datasheet before use
Western blot protocol sheet for KRT10: expected band ~58.8 kDa, hero antibody M02305-1, catalog values and labelled standard workflow; separate PMC comparisons on the guide
Printable KRT10 Western blot protocol sheet — expected band ~58.8 kDa, antibody M02305-1, controls and PMC citations. Open the full KRT10 WB guide →

KRT10 Western Blot Experimental Design Guide

Expected bands, validated protocols, controls and antibodies — the at-a-glance facts below, then the full design guide.

Must know before running
Expected band ~58.8 kDa
Observed band ~59 kDa
Gel 5–20% (catalog M02305-1)
Positive control ⓘ Skin (IHC candidate; verify WB)
Negative control ⓘ Adipose tissue (IHC candidate; verify WB)
Important caveats
Reasons your observed band may differ from the expected size.
PTM Phosphorylated
Caveat Phosphorylation-state controls
Gene-set association MSigDB C7 membership
Isoform 1 isoform(s)
Section 1

Real Curated KRT10 Western Blot Protocols

The M02305-1 protocol combines labelled catalog values with standard starting conditions. Published comparisons retain their own sample, reagent and detection scope.

Recommended Western blot protocol parameters
Sample / lysatehuman K562, human SH-SY5Y, human Jurkat (catalog M02305-1)
Gel %5–20% (catalog M02305-1)
Load30 ug; reducing conditions (catalog M02305-1)
Transfera nitrocellulose membrane at 150 mA for 50-90 minutes (catalog M02305-1)
Membranenitrocellulose membrane (catalog M02305-1)
Blocking5% non-fat milk/TBS for 1.5 hour at RT (catalog M02305-1)
Primary antibodyM02305-1 · 1:500 (catalog M02305-1)
Primary incubationovernight at 4°C (catalog M02305-1)
Secondary antibodygoat anti-rabbit IgG-HRP, 1:500 (catalog M02305-1)
Secondary incubation1.5 hour at RT (catalog M02305-1)
WashTBS-0.1%Tween 3 times with 5 minutes each (catalog M02305-1)
DetectionECL (catalog M02305-1)
Section 2

What Is the Expected KRT10 Western Blot Band Size?

KRT10 is predicted at 58.8 kDa and observed at ~59 kDa; the small difference has no established cause in the supplied evidence.

What am I looking at on my blot?
Band at ~59 kDaMatches the observed KRT10 band near its 58.8 kDa predicted mass
Higher band under nonreducing conditionsMay reflect retention of a Cys401-linked complex
Additional higher bandsMay reflect KRT10 complexes with KRT1 if they survive sample preparation
Little or no band in whole-cell lysateMay reflect KRT10's extracellular localization, although KRT10 is also reported in the cytoplasm
💡Expected KRT10 appearanceKRT10 has a predicted mass of 58.8 kDa and an observed band at ~59 kDa; confirm band identity with an appropriate positive control or KRT10 depletion.
How each factor affects band size
Predicted KRT10 mass58.8 kDa predicted; the observed band is ~59 kDa
Cys401 disulfideCould retain a higher-mass complex under nonreducing conditions
KRT1–KRT10 heterodimerCould migrate above monomeric KRT10 if retained during electrophoresis
KRT1–KRT10 heterotetramerCould produce higher-mass material if the complex remains intact
Why is my band missing or off?
SituationLikely causeNext action
No band in lysateKRT10 can localize extracellularly, and lysate expression may be lowCheck a KRT10-positive sample and compare extracellular material
Band higher than expectedA Cys401-linked complex may persist with incomplete reductionCompare reducing and nonreducing samples
Band lower than expectedIts identity is uncertain; no precursor cleavage is listedCompare with a positive control and test KRT10 depletion
Multiple bandsRetained KRT1 complexes or unrelated antibody binding may contributeCompare reduction conditions and confirm bands by KRT10 depletion
Weak or no signalKRT10 may be scarce in the tested sampleUse a KRT10-positive control and check sample loading

Sample controls for KRT10 Western blot

🧪HPA-IHC candidate guidance (verify in WB): For positive controls for KRT10 in Western blot, you can use skin tissue.
Positive control: Skin (IHC candidate; verify WB)
Negative control: Adipose tissue (IHC candidate; verify WB)
Loading controls: Run GAPDH, β-actin, and a total-protein stain alongside the samples.
⚠️Feasibility: Skin provides a positive control, but extracellular KRT10 may give variable signal in whole-cell lysate.

HPA tissue expression evidence for KRT10

Comprehensive Human Protein Atlas IHC scoring per tissue. Rows are taken directly from the HPA tissue chart — click any row's HPA link to view the source.

Higher expression tissues · candidate positive controls from IHC

TissueCell typeLevelEvidenceSource
Skin cells in corneal layer Medium Protein (IHC) HPA →

Lower expression tissues · IHC evidence, not confirmed WB-negative controls

TissueCell typeLevelEvidenceSource
Adipose tissue adipocytes Not detected Protein (IHC) HPA →
Adrenal gland glandular cells Not detected Protein (IHC) HPA →
Appendix glandular cells Not detected Protein (IHC) HPA →
Bone marrow hematopoietic cells Not detected Protein (IHC) HPA →
Breast adipocytes Not detected Protein (IHC) HPA →
Section 3

Advanced KRT10 Western Blot Tips

Deeper troubleshooting and optimisation questions for KRT10, answered from its protein features.

How should KRT10 band migration be interpreted?
Band shift · Use the separately labelled calculated mass and catalog-observed evidence above. A sequence annotation does not establish an observed migration shift. Verify target identity with orthogonal controls.
Could a second KRT10 isoform explain another band?
Isoforms · Only one isoform is listed, with no alternative sequence. These features do not support assigning another band to a KRT10 isoform.
Which KRT10 phosphorylation sites matter when interpreting bands?
PTM · UniProt lists phosphoserine at positions 14, 16, 42, 53, 56, and 170. Use those UniProt coordinates when comparing antibody or paper numbering. Their presence alone does not establish a visible band shift.

No glycosylation sites are listed. The supplied features therefore do not support attributing a heavier band to glycosylation.
Does this guide establish induction of KRT10?
Induction · No general induction response is established by this guide. A pathway or gene-set association is not evidence of induction in a particular specimen. Verify the relevant treatment and control in a target-specific experiment.
How should transfer be checked for KRT10?
Transfer · Standard workflow guidance: verify transfer efficiency for the intended target size before interpreting a weak signal. Use total-protein assessment and optimize transfer for the membrane, gel and apparatus; the labelled catalog values take precedence.
How should blocking be optimized?
Blocking · Standard workflow guidance: follow the M02305-1 datasheet where specified. Otherwise compare 5% milk or 5% BSA in TBST; for a phospho-specific assay start with BSA. Optimize background and specific signal with matched controls.
How should KRT10 be quantified?
Quantitation · Standard workflow guidance: quantify only a validated target band within the linear exposure range. Use consistent sample preparation and loading, retain biological replicates, and avoid interpreting saturation or loading differences as regulation.
How does the observed KRT10 band compare with predicted mass?
Interpretation · The observed band near 59 kDa closely matches KRT10’s predicted 58.8 kDa. The listed features do not establish a cause for any small difference in apparent mass.

KRT10 forms a heterodimer with KRT1, and two such heterodimers form a heterotetramer. A higher band cannot be identified as one of these complexes from molecular weight alone; interpretation depends on the sample and blot conditions.

KRT10 is listed in the cytoplasm, at the cell surface, and in extracellular space. When quantifying samples, compare like fractions and use the same preparation method; different fractions may contain different amounts of KRT10.

Check the band against the approximately 59 kDa observed band and 58.8 kDa predicted mass, then consider the listed phosphorylation sites and KRT1-containing complexes. One listed disulfide bond may also make reducing conditions relevant. None of these features alone identifies an unexpected band.
Boster reagents

KRT10 Western Blot Antibodies

Catalog antibodies with Western blot application and product-specific WB images. Evaluate suitability with the reported sample, controls and experimental conditions.

Real WB data Western blot analysis of KRT10 using anti-KRT10 antibody (M02305-1). <br>
Electrophoresis was performed on a 5-20% SDS-PAGE gel at 70V (Stacking gel) / 90V (Resolving gel) for 2-3 hours. The sample well of each lane was loaded with 30 ug of sample under reducing conditions. <br>
Lane 1: human K562 whole cell lysates,<br>
Lane 2: human SH-SY5Y whole cell lysates,<br>
Lane 3: human Jurkat whole cell lysates,<br>
Lane 4: rat brain tissue lysates,<br>
Lane 5: mouse brain tissue lysates.<br>
After electrophoresis, proteins were transferred to a nitrocellulose membrane at 150 mA for 50-90 minutes. Blocked the membrane with 5% non-fat milk/TBS for 1.5 hour at RT. The membrane was incubated with rabbit anti-KRT10 antigen affinity purified monoclonal antibody (Catalog # M02305-1) at 1:500 overnight at 4°C, then washed with TBS-0.1%Tween 3 times with 5 minutes each and probed with a goat anti-rabbit IgG-HRP secondary antibody at a dilution of 1:500 for 1.5 hour at RT. The signal is developed using an Enhanced Chemiluminescent detection (ECL) kit (Catalog # EK1002) with Tanon 5200 system. A specific band was detected for KRT10 at approximately 59 kDa. The expected band size for KRT10 is at 59 kDa.
Anti-Cytokeratin 10 KRT10 Rabbit Monoclonal Antibody
Cat # M02305-1
Real WB data Western blot analysis of Cytokeratin 10 on Hela cell lysates using anti-Cytokeratin 10 antibody at 1/1,000 dilution.
Anti-Cytokeratin 10 KRT10 Antibody
Cat # A02305-2
Real WB data Western Blot analysis of various cells using Cytokeratin 10 Polyclonal Antibody
Anti-Cytokeratin 10 KRT10 Antibody
Cat # A02305-1

Three the supplier anti-KRT10 antibodies list human, mouse, and rat reactivity and have WB images. Captions describe specific tested samples; the detail varies, and these examples do not establish performance across all tissues or conditions.

Which to pick: Choose M02305-1 for the most detailed WB example: human cell lines and rat and mouse brain lysates, with a reported 59 kDa band. A02305-2 shows HeLa lysate; A02305-1 describes only ‘various cells.’ Match your sample and conditions to the available evidence.

Source: BosterBio KRT10 gene-info card — filtered to Western-blot-capable antibodies; each card shows that product's actual WB validation figure.