NEUROG2 / Neurogenin-2 · Western blot design guide

Design a Western Blot for NEUROG2

Source-linked NEUROG2 Western blot protocol options, expected-band and isoform facts, troubleshooting for weak or shifted signal, and recommended anti-NEUROG2 WB antibodies. Everything you need to plan the experiment before you commit precious samples.

Evidence assembled September 2026 · For research use; verify linked source records and product datasheet before use
Western blot protocol sheet for NEUROG2: expected band ~28.6 kDa, hero antibody A10153, catalog values and labelled standard workflow; separate PMC comparisons on the guide
Printable NEUROG2 Western blot protocol sheet — expected band ~28.6 kDa, antibody A10153, controls and PMC citations. Open the full NEUROG2 WB guide →

NEUROG2 Western Blot Experimental Design Guide

Expected bands, source-linked protocol options, controls and antibodies — the at-a-glance facts below, then the full design guide.

Must know before running
Expected band ~28.6 kDa
Gel 12–15% (standard starting point)
Negative control ⓘ Suggested KO / knockdown lysate
Important caveats
Reasons your observed band may differ from the expected size.
PTM —
Caveat —
Gene-set association MSigDB C7 membership
Isoform 1 isoform(s)
Section 1

Source-Linked NEUROG2 Western Blot Protocol Options

The A10153 protocol combines labelled catalog values with standard starting conditions. Published comparisons retain their own sample, reagent and detection scope.

Recommended Western blot protocol parameters
Sample / lysatemouse small intestine tissue lysate (catalog A10153)
Gel %12–15% (standard starting point)
Load20–30 µg total protein per lane; optimize for abundance (standard starting point)
TransferShort semi-dry transfer; verify retention (standard starting point)
Membrane0.45 µm PVDF (standard starting point)
Blocking5% milk or 5% BSA in TBST (standard starting point)
Primary antibodyA10153 · (A) 1 and (B) 2 μg/mL (catalog A10153)
Primary incubationOvernight at 4 °C (standard starting point)
Secondary antibodySpecies-matched HRP conjugate at validated dilution (standard starting point)
Secondary incubation1 h at room temperature (standard starting point)
Wash3 × 5 min in TBST (standard starting point)
DetectionECL; bracket exposures to avoid saturation (standard starting point)
Section 2

What Is the Expected NEUROG2 Western Blot Band Size?

NEUROG2 is predicted at 28.6 kDa; no empirical band is supplied, and its documented features do not establish a migration shift.

What am I looking at on my blot?
Single band near 28.6 kDaConsistent with the predicted NEUROG2 mass; verify identity with controls
Band enriched in nuclear fractionConsistent with NEUROG2 nuclear localization
Weaker band in cytoplasmic fractionConsistent with NEUROG2 nuclear localization
Band at the same position in whole-cell and nuclear fractionsConsistent with the same NEUROG2 species in both samples
💡Expected NEUROG2 appearanceUniProt predicts a 28.6 kDa NEUROG2 band, but no empirical band size is supplied; verify any candidate band with ordinary identity controls.
How each factor affects band size
UniProt predicted molecular weightSets a 28.6 kDa reference for the full-length protein
Sequence-based massThe 272-residue sequence has a calculated mass of 28,621 Da
Predicted monomer massSuggests a band near 28.6 kDa if the protein migrates as predicted
UniProt mass referenceProvides a comparison point; actual gel migration is unverified
Why is my band missing or off?
SituationLikely causeNext action
No band in lysateNEUROG2 may be scarce in the sampled cellsConfirm expression and compare a nuclear-enriched fraction
Band higher than expectedNo documented size-increasing feature establishes its identityCheck specificity with NEUROG2 depletion or an independent antibody
Band lower than expectedNo documented cleavage establishes a smaller NEUROG2 productCheck sample integrity and verify identity with an independent antibody
Multiple bandsThe supplied features do not identify distinct isoform bandsCompare each band with a NEUROG2 depletion control
Weak or no signalNEUROG2 abundance may be low in the sampleConfirm expression and assess a nuclear-enriched sample

Sample controls for NEUROG2 Western blot

🧪For positive controls for NEUROG2 in Western blot, you can use an HPA-IHC candidate positive sample once one is identified; none is supplied here.
Positive control: No high/medium HPA tissue identified
Negative control: Suggested KO / knockdown lysate
Loading controls: Run GAPDH, β-actin, and a total-protein stain alongside the samples.
⚠️Feasibility: HPA provides no tissue data, so tissue-based controls cannot be confirmed.

HPA tissue expression evidence for NEUROG2

Comprehensive Human Protein Atlas IHC scoring per tissue. Rows are taken directly from the HPA tissue chart — click any row's HPA link to view the source.

Higher expression tissues · candidate positive controls from IHC

TissueCell typeLevelEvidenceSource
No high/medium HPA tissues identified in the supplied evidence.

Lower expression tissues · IHC evidence, not confirmed WB-negative controls

TissueCell typeLevelEvidenceSource
No lower-expression tissue rows available in the supplied evidence.
Section 3

Advanced NEUROG2 Western Blot Tips

Deeper troubleshooting and optimisation questions for NEUROG2, answered from its protein features.

Where should the NEUROG2 band appear?
Band shift · The predicted mass is 28.6 kDa for the 272-residue protein. No empirical apparent band position is supplied, so use 28.6 kDa as a reference rather than an exact migration target.
Are multiple NEUROG2 isoform bands expected?
Isoforms · Only one isoform is listed, with no alternative sequence. The supplied features therefore do not support assigning multiple bands to annotated isoforms.
Do annotated modifications prove a band shift?
PTM · The linked UniProt record describes protein features. A modification annotation alone does not demonstrate a visible shift; retain any condition or experimental qualifier attached to it.
Does this guide establish induction of NEUROG2?
Induction · No general induction response is established by this guide. A pathway or gene-set association is not evidence of induction in a particular specimen. Verify the relevant treatment and control in a target-specific experiment.
How should transfer be checked for NEUROG2?
Transfer · Standard workflow guidance: verify transfer efficiency for the intended target size before interpreting a weak signal. Use total-protein assessment and optimize transfer for the membrane, gel and apparatus; the labelled catalog values take precedence.
How should blocking be optimized?
Blocking · Standard workflow guidance: follow the A10153 datasheet where specified. Otherwise compare 5% milk or 5% BSA in TBST; for a phospho-specific assay start with BSA. Optimize background and specific signal with matched controls.
How should NEUROG2 be quantified?
Quantitation · Standard workflow guidance: quantify only a validated target band within the linear exposure range. Use consistent sample preparation and loading, retain biological replicates, and avoid interpreting saturation or loading differences as regulation.
Does the predicted mass explain a shifted NEUROG2 band?
Interpretation · No observed band position is supplied for comparison. The listed features include no modified residues or glycosylation sites; they do not establish the cause of a band shift.

NEUROG2 is annotated as nuclear. Include a nuclear-containing fraction when preparing samples, and compare like fractions across samples.

Efficient DNA binding requires dimerization with another bHLH protein, but that functional interaction does not establish a visible dimer band. The supplied features list no disulfide bonds.

NEUROG2 is a nuclear transcription regulator involved in neurogenesis and differentiation. Compare samples prepared from matching cell contexts and nuclear-containing fractions so differences in sample composition do not obscure the comparison.

The predicted mass is 28.6 kDa, and only one isoform is listed. An additional band cannot be assigned to an isoform or a specific modification from these features alone; verify its identity before interpreting it as NEUROG2.
Boster reagents

NEUROG2 Western Blot Antibodies

Catalog antibodies with Western blot application and product-specific WB images. Evaluate suitability with the reported sample, controls and experimental conditions.

Real WB data Western blot analysis of NGN2 in mouse small intestine tissue lysate with NGN2 antibody at (A) 1 and (B) 2 μg/mL.
Anti-NGN2 NEUROG2 Antibody
Cat # A10153
Real WB data Western blot analysis of Neurogenin 2 expression in SH-SY5Y cell lysate.
Anti-Neurogenin 2 Rabbit Monoclonal Antibody
Cat # M10153

Two the supplier anti-NEUROG2 antibodies are listed, both with stated Human, Mouse, and Rat reactivity and WB images. A10153 is shown with mouse small intestine lysate at 1 and 2 μg/mL; M10153 is shown with SH-SY5Y lysate. The supplied WB evidence is limited to these examples.

Which to pick: Choose A10153 for a WB example using mouse small intestine lysate, or M10153 for one using SH-SY5Y lysate. Both have WB images, but these examples alone do not establish performance across all listed species.

Source: BosterBio NEUROG2 gene-info card — filtered to Western-blot-capable antibodies; each card shows that product's actual WB validation figure.