This website uses cookies to ensure you get the best experience on our website.
- Table of Contents
MX1 antibody (A00849-3) performs well in ELISA, Flow Cytometry, IF, ICC, WB and shows reactivity with Human, Mouse, Rat.
- Validated for inter-lot consistency, specificity, and reproducibility
- Committed to quality since 1993
- Over 1 Publication
Filter:
Flow Cytometry analysis of SiHa cells using anti-MX1 antibody (A00849-3).
Overlay histogram showing SiHa cells stained with A00849-3 (Blue line). To facilitate intracellular staining, cells were fixed with 4% paraformaldehyde and permeabilized with permeabilization buffer. The cells were blocked with 10% normal goat serum. And then incubated with rabbit anti-MX1 Antibody (A00849-3, 1 μg/1x106 cells) for 30 min at 20°C. DyLight®488 conjugated goat anti-rabbit IgG (BA1127, 5-10 μg/1x106 cells) was used as secondary antibody for 30 minutes at 20°C. Isotype control antibody (Green line) was rabbit IgG (1 μg/1x106) used under the same conditions. Unlabelled sample without incubation with primary antibody and secondary antibody (Red line) was used as a blank control.
Overlay histogram showing SiHa cells stained with A00849-3 (Blue line). To facilitate intracellular staining, cells were fixed with 4% paraformaldehyde and permeabilized with permeabilization buffer. The cells were blocked with 10% normal goat serum. And then incubated with rabbit anti-MX1 Antibody (A00849-3, 1 μg/1x106 cells) for 30 min at 20°C. DyLight®488 conjugated goat anti-rabbit IgG (BA1127, 5-10 μg/1x106 cells) was used as secondary antibody for 30 minutes at 20°C. Isotype control antibody (Green line) was rabbit IgG (1 μg/1x106) used under the same conditions. Unlabelled sample without incubation with primary antibody and secondary antibody (Red line) was used as a blank control.
Bundle Save
Anti-MX1 Antibody Picoband®
MX1 antibody
| Reactive Species | Host | Application |
|---|---|---|
| Human, Mouse, Rat | Rabbit | ELISA, Flow Cytometry, IF, ICC, WB |
Tested Applications
MX1 antibody was positively detected by WB in:
human A431 whole cell, human Caco-2 whole cell, human SiHa whole cell, human PC-3 whole cell, rat PC-12 whole cell, mouse RAW264.7 whole cell
Suggested blocking solution with 5% non-fat milk or BSA; (*)Recommended protein loading: 20-40 ug per lane
MX1 antibody was positively detected by ICC/IF in:
SiHa cell
MX1 antibody was positively detected by FC in:
SiHa cell
Recommend Dilution
Application
Dilution
Species
Western blot
0.25-0.5 μg/ml
Human, Mouse, Rat
Immunocytochemistry/Immunofluorescence
5 μg/ml
Human
Flow Cytometry (Fixed)
1-3 μg/1x106 cells
Human
ELISA
0.1-0.5 μg/ml
* It is recommended to optimize the amount of this reagent in each experimental system to achieve the best results.
Note: For flow cytometry (FCM), suitable for fixed cells only. Not suitable for FACS or surface flow cytometry using live cells.
Reactive Data
Filter:
Boster Guarantee:What is this?
WB
ELISA
Human
Tested
Recommend
Rat
Tested
Recommend
Mouse
Tested
Recommend
Monkey
Predicted
Predicted
Product Information
Product Name
Anti-MX1 Antibody Picoband®
View all MX1 Antibodies
View all MX1 Antibodies
Form
Lyophilized
Uniprot
Gene ID
Storage & Handling
At -20°C for one year from date of receipt.
After reconstitution, at 4°C for one month. It can also be aliquotted and stored frozen at -20°C for six months.
Avoid repeated freezing and thawing.
Host
Rabbit
Contents
Each vial contains 4 mg Trehalose, 0.9 mg NaCl, 0.2 mg Na2HPO4.
Clonality
Polyclonal
Immunogen
E.coli-derived human MX1 recombinant protein (Position: E315G-662).
Reconstitution
Adding 0.2 ml of distilled water will yield a concentration of 500 μg/ml.
Observed Molecular Weight
76 kDa
Calculated Molecular Weight
75.5 kDa
Background of MX1
In mouse, the interferon-inducible Mx protein is responsible for a specific antiviral state against influenza virus infection. The protein encoded by this gene is similar to the mouse protein as determined by its antigenic relatedness, induction conditions, physicochemical properties, and amino acid analysis. This cytoplasmic protein is a member of both the dynamin family and the family of large GTPases. Two transcript variants encoding the same protein have been found for this gene.
Cite This Product
Anti-MX1 Antibody Picoband® (Boster Biological Technology, Pleasanton CA, USA, Catalog # A00849-3)
Antibody Homology Across Species
The results generated by this homology analysis tool for commonly used animal species are shown below. For unlisted species, please refer to the homology analysis between the immunogen sequence and the corresponding species.
A homology of ≥90% is recommended. Generally, higher homology indicates a greater potential for cross-species reactivity. However, protein expression levels may vary among different species, tissues, and cell types. Therefore, the homology analysis results are for reference only and do not guarantee antibody cross-reactivity or experimental performance.
Human
100%
High Homology
Monkey
93%
High Homology
Dog
74%
Moderate Homology
Cow
72%
Moderate Homology
Sheep
72%
Moderate Homology
Rat
71%
Moderate Homology
Rabbit
64%
Low homology
Zebrafish
44%
Low homology
Homology ≥ 90%High Homology
70% ≤ Homology < 90%Moderate Homology
Homology < 70%Low homology
Protocols
Western Blot protocol for MX1 antibody
Immunocytochemistry/Immunofluorescence (ICC/IF) protocol for MX1 antibody
Flow Cytometry (FC) protocol for MX1 antibody
Publications
Application:
Species:
Ursodeoxycholic acid inhibits pneumonia caused by PRCV through the activation of TLR4-IRF3 mediated type Ⅰ interferon pathway
Published: 2026-03-02
Journal: VETERINARY RESEARCH
Application: WB
Impact Factor: 3.50
Species: Porcine
Review
Have you used Anti-MX1 Antibody Picoband®?
Submit a review and receive $370 in product credits, a $185 Amazon gift card, or our carefully curated gift bundles.
Product Promise
We promise Anti-MX1 Antibody Picoband® performs excellently in relevant applications for ELISA, Flow Cytometry, IF, ICC, WB. If it doesn't perform as promised, we will refund the product. Learn more
In stock
Order Product
A00849-3
Buy one primary antibody get one 0.5ml HRP or Biotin secondary antibody for free.
*Sample sizes are prepared on demand and will take extra lead time. (cannot be conjugated)
$370.00
Troubleshooting
Boster Guarantee
Guaranteed product quality
We promise all of our products perform as described in datasheets.
This product is for Research Use Only. Not for use in diagnostic procedures.
Update date:
Oct 8, 2026