IL23R Western Blot Experimental Design Guide

Expected bands, validated protocols, controls and antibodies — the at-a-glance facts below, then the full design guide.

Must know before running
Expected band 71.7 kDa observed
Observed band 71.7 kDa observed
Gel 12-15%
Positive control ⓘ Lung
Negative control ⓘ Adipose tissue
Important caveats
Reasons your observed band may differ from the expected size.
ⓘCalculated mass71.7 kDa
ⓘLocalizationCell membrane
ⓘProcessing / PTMRecord-dependent
ⓘReactivityHuman
Section 1

Real Curated IL23R Western Blot Protocols

Start with the molecular-weight rule, then compare verified publication-derived conditions.

Recommended Western blot protocol parameters
Sample / lysateLung
Gel %12-15%
Load20-30 µg total protein per lane
TransferSemi-dry, standard transfer
Membrane0.45 µm PVDF
Blocking5% non-fat milk or 5% BSA in TBST
PrimaryA00607-3 at datasheet starting dilution
Primary incubationOvernight at 4 °C with gentle agitation
SecondarySpecies-matched HRP conjugate at validated dilution
Wash3 × 5 min in TBST
DetectionChemiluminescent substrate
ExposureBracket exposures to avoid saturation
Section 2

What Is the Expected IL23R Western Blot Band Size?

Use the product-observed 71.7 kDa band as the primary planning value and retain the UniProt calculated mass as context.

What am I looking at on my blot?
71.7 kDaMatches the authoritative product WB observation.
71.7 kDa calculatedUse as UniProt context, not as a replacement observed band.
Unexpected additional signalDo not assign identity without orthogonal positive/negative controls.
💡Expected IL23R appearancePlan around 71.7 kDa and keep the calculated mass as supporting context.
How each factor affects band size
Catalog-observed band71.7 kDa; use this as the primary experimental expectation.
Calculated mass71.7 kDa from UniProt Q5VWK5; retain as context.
Gel selection12-15%; shared with the recommended protocol and poster.
Specificity checkCompare the lead HPA positive and negative controls with A00607-3.
Why is my band missing or off?
SituationLikely causeNext action
71.7 kDaMatches the authoritative product WB observation.Confirm with orthogonal controls and the linked product record.
Additional bandMay reflect processing, modification, or non-specific signal.Run a dilution series and compare positive/negative controls.
Weak signalTarget abundance or transfer may be limiting.Verify transfer, increase positive-control abundance, and bracket exposure.

Sample controls for IL23R Western blot

🧪Use Lung as the first positive-control candidate and retain an orthogonal negative control.
Positive control: Lung (Low)
Negative control: Adipose tissue (Not detected)
HPA protein score determines control status; other expression data is supporting context only.

HPA tissue expression evidence for IL23R

Comprehensive Human Protein Atlas IHC scoring per tissue. Rows are taken directly from the HPA tissue chart on each tissue page — click any row's HPA link to view the source.

Positive expression · recommended positive controls

Tissue Cell type Level Evidence Source
Lung Reported tissue cells Low Protein (HPA) HPA →

Undetected expression · recommended negative controls

Tissue Cell type Level Evidence Source
Adipose tissue Reported tissue cells Not detected Protein (HPA) HPA →
Adrenal gland Reported tissue cells Not detected Protein (HPA) HPA →
Appendix Reported tissue cells Not detected Protein (HPA) HPA →
Adrenal gland Reported tissue cells Not detected Protein (HPA) HPA →
Appendix Reported tissue cells Not detected Protein (HPA) HPA →
Section 3

Advanced IL23R Western Blot Tips

Deeper troubleshooting and optimisation questions for IL23R, answered from its protein features.

Which band should guide the blot?
Use 71.7 kDa, the observation attached to the authoritative A00607-3 WB record.
How should calculated mass be interpreted?
Treat the UniProt calculated mass as context; it does not replace the catalog-observed 71.7 kDa expectation.
Which positive control should I start with?
Start with Lung, the lead HPA protein-expression candidate.
Which negative control is defensible?
Use Adipose tissue as an orthogonal HPA Not detected candidate.
Which gel should I use?
Use 12-15% consistently across the quick facts, protocol table, and poster.
What transfer method to use for IL23R Western blot?
Use the transfer method in the recommended protocol and verify transfer before blocking.
How should A00607-3 be started?
Start at the linked datasheet condition and run a three-point primary-antibody dilution test.
Which publication-derived protocols can I compare?
No verified publication protocol was supplied; use only the deterministic recommended protocol.
Boster reagents

IL23R Western Blot Reagents

Human-reactive IL23R Western blot reagents with authoritative product imagery.

Real WB dataWestern blot validation image for IL23R using A00607-3; observed band 71.7 kDa
Anti-IL23 Receptor/IL23R Antibody Picoband®
Cat # A00607-3

Only image-backed, WB-validated Human/Mouse/Rat recommendations from the prepared catalog evidence are shown.

Source: prepared picoband-wb product evidence; each card retains its own SKU, URL, observed band, and authoritative WB image.