This website uses cookies to ensure you get the best experience on our website.
- Table of Contents
FAM13A antibody (A07079-1) performs well in ELISA, Flow Cytometry, WB and shows reactivity with Human.
- Validated for inter-lot consistency, specificity, and reproducibility
- Committed to quality since 1993
Filter:
Flow Cytometry analysis of RT4 cells using anti-FAM13A antibody (A07079-1).
Overlay histogram showing RT4 cells stained with A07079-1 (Blue line). To facilitate intracellular staining, cells were fixed with 4% paraformaldehyde and permeabilized with permeabilization buffer. The cells were blocked with 10% normal goat serum. And then incubated with rabbit anti-FAM13A Antibody (A07079-1, 1 μg/1x106 cells) for 30 min at 20°C. Fluoro488 conjugated goat anti-rabbit IgG (BA1127, 5-10 μg/1x106 cells) was used as secondary antibody for 30 minutes at 20°C. Isotype control antibody (Green line) was rabbit IgG (1 μg/1x106) used under the same conditions. Unlabelled sample without incubation with primary antibody and secondary antibody (Red line) was used as a blank control.
Overlay histogram showing RT4 cells stained with A07079-1 (Blue line). To facilitate intracellular staining, cells were fixed with 4% paraformaldehyde and permeabilized with permeabilization buffer. The cells were blocked with 10% normal goat serum. And then incubated with rabbit anti-FAM13A Antibody (A07079-1, 1 μg/1x106 cells) for 30 min at 20°C. Fluoro488 conjugated goat anti-rabbit IgG (BA1127, 5-10 μg/1x106 cells) was used as secondary antibody for 30 minutes at 20°C. Isotype control antibody (Green line) was rabbit IgG (1 μg/1x106) used under the same conditions. Unlabelled sample without incubation with primary antibody and secondary antibody (Red line) was used as a blank control.
Bundle Save
Anti-FAM13A Antibody Picoband®
FAM13A antibody
| Reactive Species | Host | Application |
|---|---|---|
| Human | Rabbit | ELISA, Flow Cytometry, WB |
Tested Applications
FAM13A antibody was positively detected by WB in:
human RT4 whole cell, human K562 whole cell
Suggested blocking solution with 5% non-fat milk or BSA; (*)Recommended protein loading: 20-40 ug per lane
FAM13A antibody was positively detected by FC in:
RT4 cell
Recommend Dilution
Application
Dilution
Species
Western blot
0.25-0.5 μg/ml
Human
Flow Cytometry (Fixed)
1-3 μg/1x106 cells
Human
ELISA
0.1-0.5 μg/ml
* It is recommended to optimize the amount of this reagent in each experimental system to achieve the best results.
Note: For flow cytometry (FCM), validated for fixed cells only. Not validated for FACS or surface flow cytometry using live cells.
Product Information
Product Name
Anti-FAM13A Antibody Picoband®
View all FAM13A Antibodies
View all FAM13A Antibodies
Form
Lyophilized
Uniprot
Gene ID
Storage & Handling
At -20°C for one year from date of receipt.
After reconstitution, at 4°C for one month. It can also be aliquotted and stored frozen at -20°C for six months.
Avoid repeated freezing and thawing.
Host
Rabbit
Contents
Each vial contains 4 mg Trehalose, 0.9 mg NaCl, 0.2 mg Na2HPO4.
Clonality
Polyclonal
Immunogen
E.coli-derived human FAM13A recombinant protein (Position: R16-D920).
Reconstitution
Adding 0.2 ml of distilled water will yield a concentration of 500 μg/ml.
Observed Molecular Weight
90 kDa
Calculated Molecular Weight
116.9 kDa
Background of FAM13A
Predicted to enable GTPase activator activity. Predicted to be involved in regulation of small GTPase mediated signal transduction. Predicted to be located in cytosol. Implicated in chronic obstructive pulmonary disease.
Cite This Product
Anti-FAM13A Antibody Picoband® (Boster Biological Technology, Pleasanton CA, USA, Catalog # A07079-1)
Antibody Homology Across Species
The results generated by this homology analysis tool for commonly used animal species are shown below. For unlisted species, please refer to the homology analysis between the immunogen sequence and the corresponding species.
A homology of ≥90% is recommended. Generally, higher homology indicates a greater potential for cross-species reactivity. However, protein expression levels may vary among different species, tissues, and cell types. Therefore, the homology analysis results are for reference only and do not guarantee antibody cross-reactivity or experimental performance.
Human
100%
High Homology
Dog
87%
Moderate Homology
Cow
84%
Moderate Homology
Sheep
84%
Moderate Homology
Rabbit
80%
Moderate Homology
Monkey
63%
Low homology
Mouse
53%
Low homology
Zebrafish
52%
Low homology
Rat
52%
Low homology
Drosophila
18%
Low homology
Homology ≥ 90%High Homology
70% ≤ Homology < 90%Moderate Homology
Homology < 70%Low homology
Protocols
Western Blot protocol for FAM13A antibody
Flow Cytometry (FC) protocol for FAM13A antibody
Review
Have you used Anti-FAM13A Antibody Picoband®?
Submit a review and receive an Amazon gift card.
$30 for a review with an image
Submit A ReviewProduct Promise
We promise Anti-FAM13A Antibody Picoband® performs excellently in relevant applications for ELISA, Flow Cytometry, WB. If it doesn't perform as promised, we will refund the product. Learn more
In stock
Order Product
A07079-1
Buy one primary antibody get one 0.5ml HRP or Biotin secondary antibody for free.
*Sample sizes are prepared on demand and will take extra lead time. (cannot be conjugated)
$370.00
Troubleshooting
Boster Guarantee
Guaranteed product quality
We promise all of our products perform as described in datasheets.
This product is for Research Use Only. Not for use in diagnostic procedures.
Update date:
Sep 22, 2026