DDX6 Western Blot Experimental Design Guide

Expected bands, validated protocols, controls and antibodies — the at-a-glance facts below, then the full design guide.

Must know before running
Expected band 54.4 kDa observed
Observed band 54.4 kDa observed
Gel 12-15%
Positive control Colon
Negative control Use knockout/knockdown or orthogonal negative
Important caveats
Reasons your observed band may differ from the expected size.
Calculated mass54.4 kDa
LocalizationCytoplasm, P-body / Cytoplasm
Processing / PTMRecord-dependent
ReactivityHuman / Mouse / Rat
Section 1

Real Curated DDX6 Western Blot Protocols

Start with the molecular-weight rule, then compare verified publication-derived conditions.

Recommended Western blot protocol parameters
Sample / lysateAppendix
Gel %12-15%
Load20-30 µg total protein per lane
TransferSemi-dry, standard transfer
Membrane0.45 µm PVDF
Blocking5% non-fat milk or 5% BSA in TBST
PrimaryA03826-1 at datasheet starting dilution
Primary incubationOvernight at 4 °C with gentle agitation
SecondarySpecies-matched HRP conjugate at validated dilution
Wash3 × 5 min in TBST
DetectionChemiluminescent substrate
ExposureBracket exposures to avoid saturation
Section 2

What Is the Expected DDX6 Western Blot Band Size?

Use the product-observed 54.4 kDa band as the primary planning value and retain the UniProt calculated mass as context.

What am I looking at on my blot?
54.4 kDaMatches the authoritative product WB observation.
54.4 kDa calculatedUse as UniProt context, not as a replacement observed band.
Unexpected additional signalDo not assign identity without orthogonal positive/negative controls.
💡Expected DDX6 appearancePlan around 54.4 kDa and keep the calculated mass as supporting context.
How each factor affects band size
Catalog-observed band54.4 kDa; use this as the primary experimental expectation.
Calculated mass54.4 kDa from UniProt P26196; retain as context.
Gel selection12-15%; shared with the recommended protocol and poster.
Specificity checkCompare the lead HPA positive and negative controls with A03826-1.
Why is my band missing or off?
SituationLikely causeNext action
54.4 kDaMatches the authoritative product WB observation.Confirm with orthogonal controls and the linked product record.
Additional bandMay reflect processing, modification, or non-specific signal.Run a dilution series and compare positive/negative controls.
Weak signalTarget abundance or transfer may be limiting.Verify transfer, increase positive-control abundance, and bracket exposure.

Sample controls for DDX6 Western blot

🧪Use Colon as the first positive-control candidate and retain an orthogonal negative control.
Positive control: Colon (High)
HPA protein score determines control status; other expression data is supporting context only.

HPA tissue expression evidence for DDX6

Comprehensive Human Protein Atlas IHC scoring per tissue. Rows are taken directly from the HPA tissue chart on each tissue page — click any row's HPA link to view the source.

Positive expression · recommended positive controls

Tissue Cell type Level Evidence Source
Colon Reported tissue cells High Protein (HPA) HPA →
Esophagus Reported tissue cells High Protein (HPA) HPA →
Appendix Reported tissue cells High Protein (HPA) HPA →
Duodenum Reported tissue cells High Protein (HPA) HPA →
Skeletal muscle Reported tissue cells Low Protein (HPA) HPA →
Hippocampus Reported tissue cells Low Protein (HPA) HPA →

Undetected expression · recommended negative controls

The available HPA profile lists no reliably-negative tissue for DDX6 (a broadly-expressed target). Use a DDX6 knockdown (siRNA/shRNA) or knockout lysate as the negative control and confirm signal loss versus the parental lysate.
Tissue Cell type Level Evidence Source
Section 3

Advanced DDX6 Western Blot Tips

Deeper troubleshooting and optimisation questions for DDX6, answered from its protein features.

Which band should guide the blot?
Use 54.4 kDa, the observation attached to the authoritative A03826-1 WB record.
How should calculated mass be interpreted?
Treat the UniProt calculated mass as context; it does not replace the catalog-observed 54.4 kDa expectation.
Which positive control should I start with?
Start with Colon, the lead HPA protein-expression candidate.
Which negative control is defensible?
Use a target knockdown/knockout control when no HPA Not detected tissue is available.
Which gel should I use?
Use 12-15% consistently across the quick facts, protocol table, and poster.
What transfer method to use for DDX6 Western blot?
Use the transfer method in the recommended protocol and verify transfer before blocking.
How should A03826-1 be started?
Start at the linked datasheet condition and run a three-point primary-antibody dilution test.
Which publication-derived protocols can I compare?
No verified publication protocol was supplied; use only the deterministic recommended protocol.
Boster reagents

DDX6 Western Blot Reagents

Human/Mouse/Rat-reactive DDX6 Western blot reagents with authoritative product imagery.

Real WB dataWestern blot validation image for DDX6 using A03826-1; observed band 54.4 kDa
Anti-DDX6 Antibody Picoband®
Cat # A03826-1
Real WB dataWestern blot validation image for DDX6 using M03826-1; observed band 54.4 kDa
Anti-DDX6 Antibody Picoband® (monoclonal, 8G6)
Cat # M03826-1

Only image-backed, WB-validated Human/Mouse/Rat recommendations from the prepared catalog evidence are shown.

Source: prepared picoband-wb product evidence; each card retains its own SKU, URL, observed band, and authoritative WB image.