SIRT3 Western Blot Experimental Design Guide

Expected bands, validated protocols, controls and antibodies — the at-a-glance facts below, then the full design guide.

Must know before running
Expected band 43.6 kDa observed
Observed band 43.6 kDa observed
Gel 12-15%
Positive control ⓘ Cerebellum
Negative control ⓘ Use knockout/knockdown or orthogonal negative
Important caveats
Reasons your observed band may differ from the expected size.
ⓘCalculated mass43.6 kDa
ⓘLocalizationMitochondrion matrix
ⓘProcessing / PTMRecord-dependent
ⓘReactivityHuman / Mouse / Rat
Section 1

Real Curated SIRT3 Western Blot Protocols

Start with the molecular-weight rule, then compare verified publication-derived conditions.

Recommended Western blot protocol parameters
Sample / lysateAdrenal gland
Gel %12-15%
Load20-30 µg total protein per lane
TransferSemi-dry, standard transfer
Membrane0.45 µm PVDF
Blocking5% non-fat milk or 5% BSA in TBST
PrimaryA01061-4 at datasheet starting dilution
Primary incubationOvernight at 4 °C with gentle agitation
SecondarySpecies-matched HRP conjugate at validated dilution
Wash3 × 5 min in TBST
DetectionChemiluminescent substrate
ExposureBracket exposures to avoid saturation
Section 2

What Is the Expected SIRT3 Western Blot Band Size?

Use the product-observed 43.6 kDa band as the primary planning value and retain the UniProt calculated mass as context.

What am I looking at on my blot?
43.6 kDaMatches the authoritative product WB observation.
43.6 kDa calculatedUse as UniProt context, not as a replacement observed band.
Unexpected additional signalDo not assign identity without orthogonal positive/negative controls.
💡Expected SIRT3 appearancePlan around 43.6 kDa and keep the calculated mass as supporting context.
How each factor affects band size
Catalog-observed band43.6 kDa; use this as the primary experimental expectation.
Calculated mass43.6 kDa from UniProt Q9NTG7; retain as context.
Gel selection12-15%; shared with the recommended protocol and poster.
Specificity checkCompare the lead HPA positive and negative controls with A01061-4.
Why is my band missing or off?
SituationLikely causeNext action
43.6 kDaMatches the authoritative product WB observation.Confirm with orthogonal controls and the linked product record.
Additional bandMay reflect processing, modification, or non-specific signal.Run a dilution series and compare positive/negative controls.
Weak signalTarget abundance or transfer may be limiting.Verify transfer, increase positive-control abundance, and bracket exposure.

Sample controls for SIRT3 Western blot

🧪Use Cerebellum as the first positive-control candidate and retain an orthogonal negative control.
Positive control: Cerebellum (High)
HPA protein score determines control status; other expression data is supporting context only.

HPA tissue expression evidence for SIRT3

Comprehensive Human Protein Atlas IHC scoring per tissue. Rows are taken directly from the HPA tissue chart on each tissue page — click any row's HPA link to view the source.

Positive expression · recommended positive controls

Tissue Cell type Level Evidence Source
Cerebellum Reported tissue cells High Protein (HPA) HPA →
Caudate Reported tissue cells High Protein (HPA) HPA →
Breast Reported tissue cells High Protein (HPA) HPA →
Adrenal gland Reported tissue cells High Protein (HPA) HPA →
Lung Reported tissue cells Low Protein (HPA) HPA →
Appendix Reported tissue cells Medium Protein (HPA) HPA →

Undetected expression · recommended negative controls

The available HPA profile lists no reliably-negative tissue for SIRT3 (a broadly-expressed target). Use a SIRT3 knockdown (siRNA/shRNA) or knockout lysate as the negative control and confirm signal loss versus the parental lysate.
Tissue Cell type Level Evidence Source
Section 3

Advanced SIRT3 Western Blot Tips

Deeper troubleshooting and optimisation questions for SIRT3, answered from its protein features.

Which band should guide the blot?
Use 43.6 kDa, the observation attached to the authoritative A01061-4 WB record.
How should calculated mass be interpreted?
Treat the UniProt calculated mass as context; it does not replace the catalog-observed 43.6 kDa expectation.
Which positive control should I start with?
Start with Cerebellum, the lead HPA protein-expression candidate.
Which negative control is defensible?
Use a target knockdown/knockout control when no HPA Not detected tissue is available.
Which gel should I use?
Use 12-15% consistently across the quick facts, protocol table, and poster.
What transfer method to use for SIRT3 Western blot?
Use the transfer method in the recommended protocol and verify transfer before blocking.
How should A01061-4 be started?
Start at the linked datasheet condition and run a three-point primary-antibody dilution test.
Which publication-derived protocols can I compare?
No verified publication protocol was supplied; use only the deterministic recommended protocol.
Boster reagents

SIRT3 Western Blot Reagents

Human/Mouse/Rat-reactive SIRT3 Western blot reagents with authoritative product imagery.

Real WB dataWestern blot validation image for SIRT3 using A01061-4; observed band 43.6 kDa
Anti-SIRT3 Antibody Picoband®
Cat # A01061-4
Real WB dataWestern blot validation image for SIRT3 using PB9161; observed band 43.6 kDa
Anti-SIRT3 Antibody Picoband®
Cat # PB9161

Only image-backed, WB-validated Human/Mouse/Rat recommendations from the prepared catalog evidence are shown.

Source: prepared picoband-wb product evidence; each card retains its own SKU, URL, observed band, and authoritative WB image.