This website uses cookies to ensure you get the best experience on our website.
- Table of Contents
Aqp3 antibody (A02181) performs well in WB and shows reactivity with Human, Mouse, Rat.
- Validated for inter-lot consistency, specificity, and reproducibility
- Committed to quality since 1993
- Over 1 Publication
Filter:
Western blot analysis of Aquaporin 3 using anti-Aquaporin 3 antibody (A02181).
Electrophoresis was performed on a 5-20% SDS-PAGE gel at 70V (Stacking gel) / 90V (Resolving gel) for 2-3 hours. The sample well of each lane was loaded with 50ug of sample under reducing conditions.
Lane 1: mouse kidney tissue lysates,
Lane 2: mouse brain tissue lysates,
Lane 3: rat kidney tissue lysates,
Lane 4: rat brain tissue lysates.
After Electrophoresis, proteins were transferred to a Nitrocellulose membrane at 150mA for 50-90 minutes. Blocked the membrane with 5% Non-fat Milk/ TBS for 1.5 hour at RT. The membrane was incubated with rabbit anti-Aquaporin 3 antigen affinity purified polyclonal antibody (Catalog # A02181) at 0.5 μg/mL overnight at 4°C, then washed with TBS-0.1%Tween 3 times with 5 minutes each and probed with a goat anti-rabbit IgG-HRP secondary antibody at a dilution of 1:10000 for 1.5 hour at RT. The signal is developed using an Enhanced Chemiluminescent detection (ECL) kit (Catalog # EK1002) with Tanon 5200 system. A specific band was detected for Aquaporin 3 at approximately 32KD. The expected band size for Aquaporin 3 is at 32KD.
Electrophoresis was performed on a 5-20% SDS-PAGE gel at 70V (Stacking gel) / 90V (Resolving gel) for 2-3 hours. The sample well of each lane was loaded with 50ug of sample under reducing conditions.
Lane 1: mouse kidney tissue lysates,
Lane 2: mouse brain tissue lysates,
Lane 3: rat kidney tissue lysates,
Lane 4: rat brain tissue lysates.
After Electrophoresis, proteins were transferred to a Nitrocellulose membrane at 150mA for 50-90 minutes. Blocked the membrane with 5% Non-fat Milk/ TBS for 1.5 hour at RT. The membrane was incubated with rabbit anti-Aquaporin 3 antigen affinity purified polyclonal antibody (Catalog # A02181) at 0.5 μg/mL overnight at 4°C, then washed with TBS-0.1%Tween 3 times with 5 minutes each and probed with a goat anti-rabbit IgG-HRP secondary antibody at a dilution of 1:10000 for 1.5 hour at RT. The signal is developed using an Enhanced Chemiluminescent detection (ECL) kit (Catalog # EK1002) with Tanon 5200 system. A specific band was detected for Aquaporin 3 at approximately 32KD. The expected band size for Aquaporin 3 is at 32KD.
Designing a Western blot for AQP3? The guide covers the expected band size, antibodies backed by real blot images, the controls to run alongside, and protocols taken from published papers.
Open the AQP3 Western Blot GuideBundle Save
Anti-Aquaporin 3/Aqp3 Antibody Picoband®
Aqp3 antibody
| Reactive Species | Host | Application |
|---|---|---|
| Human, Mouse, Rat | Rabbit | WB |
Tested Applications
Aqp3 antibody was positively detected by WB in:
mouse kidney tissue, mouse brain tissue, rat kidney tissue, rat brain tissue
Suggested blocking solution with 5% non-fat milk or BSA; (*)Recommended protein loading: 20-40 ug per lane
Recommend Dilution
Application
Dilution
Species
Western blot
0.1-0.5μg/ml
Mouse, Rat, Human
* It is recommended to optimize the amount of this reagent in each experimental system to achieve the best results.
Product Information
Product Name
Anti-Aquaporin 3/Aqp3 Antibody Picoband®
View all AQP3 Antibodies
View all AQP3 Antibodies
Form
Lyophilized
Uniprot
Gene ID
Storage & Handling
Store at -20˚C for one year from date of receipt. After reconstitution, at 4˚C for one month. It can also be aliquotted and stored frozen at -20˚C for six months. Avoid repeated freeze-thaw cycles.
Host
Rabbit
Contents
Each vial contains 4mg Trehalose, 0.9mg NaCl, 0.2mg Na2HPO4, 0.05mg NaN3.
Clonality
Polyclonal
Isotype
Rabbit IgG
Immunogen
A synthetic peptide corresponding to a sequence in the middle region of mouse Aquaporin 3, different from the related human sequence by three amino acids, and from the related rat sequence by two amino acids.
Cross-Reactivity
No cross-reactivity with other proteins.
Reconstitution
Add 0.2ml of distilled water will yield a concentration of 500ug/ml.
Observed Molecular Weight
32 kDa
Calculated Molecular Weight
31.6 kDa
Background of Aqp3
This gene encodes the water channel protein aquaporin 3. Aquaporins are a family of small integral membrane proteins related to the major intrinsic protein, also known as aquaporin 0. Aquaporin 3 is localized at the basal lateral membranes of collecting duct cells in the kidney. In addition to its water channel function, aquaporin 3 has been found to facilitate the transport of nonionic small solutes such as urea and glycerol, but to a smaller degree. It has been suggested that water channels can be functionally heterogeneous and possess water and solute permeation mechanisms. Alternative splicing of this gene results in multiple transcript variants encoding different isoforms.
Cite This Product
Anti-Aquaporin 3/Aqp3 Antibody Picoband® (Boster Biological Technology, Pleasanton CA, USA, Catalog # A02181)
Antibody Homology Across Species
The results generated by this homology analysis tool for commonly used animal species are shown below. For unlisted species, please refer to the homology analysis between the immunogen sequence and the corresponding species.
A homology of ≥90% is recommended. Generally, higher homology indicates a greater potential for cross-species reactivity. However, protein expression levels may vary among different species, tissues, and cell types. Therefore, the homology analysis results are for reference only and do not guarantee antibody cross-reactivity or experimental performance.
Mouse
100%
High Homology
Rat
88%
Moderate Homology
Cow
88%
Moderate Homology
Sheep
88%
Moderate Homology
Human
81%
Moderate Homology
Dog
81%
Moderate Homology
Monkey
81%
Moderate Homology
Rabbit
75%
Moderate Homology
Zebrafish
56%
Low homology
Drosophila
19%
Low homology
Homology ≥ 90%High Homology
70% ≤ Homology < 90%Moderate Homology
Homology < 70%Low homology
Protocols
Western Blot protocol for Aqp3 antibody
Publications
Application:
Species:
Effects of Mume Fructus extract on smoking-induced cough and TNBS-induced colitis in rats and its underlying mechanisms based on gut-lung body fluid metabolism
Published: 2025-09-13
Journal: JOURNAL OF ETHNOPHARMACOLOGY
Application: WB
Impact Factor: 5.40
Species: Rat
PMID: 40953772
Review
Have you used Anti-Aquaporin 3/Aqp3 Antibody Picoband®?
Submit a review and receive $370 in product credits, a $185 Amazon gift card, or our carefully curated gift bundles.
Product Promise
We promise Anti-Aquaporin 3/Aqp3 Antibody Picoband® performs excellently in relevant applications for WB. If it doesn't perform as promised, we will refund the product. Learn more
In stock
Order Product
A02181
Buy one primary antibody get one 0.5ml HRP or Biotin secondary antibody for free.
*Sample sizes are prepared on demand and will take extra lead time. (cannot be conjugated)
$370.00
Troubleshooting
Boster Guarantee
Guaranteed product quality
We promise all of our products perform as described in datasheets.
This product is for Research Use Only. Not for use in diagnostic procedures.
Update date:
Oct 26, 2026